Rebuilding the collapsed stretch of dry stone wall

Eight metres of the wall below the orchard fell outright after the wet winter, a slow slump that finished in a single night. The good news about a dry stone wall is that nothing is lost. Every stone is lying there at the base, and the job is mostly one of sorting and patience.

Sort first

I cleared the line down to firm ground and sorted the stone into piles: large foundation stones, ordinary walling stones, long through stones, small hearting, and flat coping stones. Spending a whole day on sorting felt slow. It paid back immediately, because every stone you pick up twice costs time.

Why it fell

Before rebuilding, find out why a wall failed. Mine had a soft foundation where a drain had been blocked, so the water saturated the bank behind and pushed the base out. I dug a shallow trench and laid a line of rubble to carry water away along the back of the wall, which should reduce the pressure.

Foundation and batter

Dig the base down to firm subsoil, about 15 cm, and set the biggest stones in it, flat faces up, with their long axis running into the wall. A dry stone wall is wider at the bottom than the top, a slope known as the batter. Mine is about 60 cm wide at the base and 30 cm at the top, for a height of a little under a metre. I made two timber frames, cut to that profile, and strung a line between them to follow. It is far easier than judging by eye.

The two faces

Build both faces up together, a course at a time. Each stone should sit on two below it, covering the vertical joint, so that no joint runs straight up. This is the rule of one over two, two over one. Place stones with their long side running into the wall rather than along it, tilting very slightly toward the centre so water moves inward and not out. Check each stone for wobble. If it rocks, pack a small wedge, called a pinning, underneath from the back.

Hearting

The gap between the two faces is filled with small stone, firmly packed as you go. Do not tip it in at the end. Loose hearting settles and pushes the faces apart. I use a short piece of wood to ram it down every course.

Through stones

At about half the finished height, lay a line of through stones, each one long enough to span the full width of the wall and tie both faces together. Space them roughly a metre apart. I had only five proper ones among the rubble, so I used them here and saved a few for a second line just below the top.

Coping

The top is finished with coping stones set on edge, tightly side by side, a little like books on a shelf. They are heavy and they lock the whole structure in place. Choose the ones with a similar height, and wedge them with small stones. Do this on a dry day, since a wet top course slips.

Pace

I managed about a metre a day on my own. A properly built wall should not need mortar or any repair for decades, and each season I walk along and push back any stone that has worked loose. Small problems are easy to fix. A bulge left alone is next year's collapse.

← All posts